
If a tray’s lower edge catches while the upper walls fit, inspect the first layers before scaling the whole model. I would compare the bottom and mid-height dimensions with a small test piece. Global scaling can create new errors in card wells and lid features that were already correct.
On this page
Our recommendation
I would diagnose the location of the interference before sanding or scaling. Keep a small corner coupon as a repeatable fit gauge for future prints of the same organiser.
Locate the excess material
Prusa explains elephant foot as a first-layer widening associated with the way material is pressed against the print bed. Its slicer compensation targets that local effect. This is different from a model that is too large throughout its height or a corner that has warped upward.
Look along the lower edge under good light and measure at several heights. Compare both axes. Avoid dragging the edge through the game box repeatedly; use a cardboard gauge or a printed mating sample. A rough seam or stray string can also cause a local catch, so inspect before changing settings.
Change one cause at a time
Check the printer’s first-layer setup and the slicer’s current profile. If compensation is appropriate, use the documented control for that slicer and run a small sample. Do not adopt a universal compensation number from a different nozzle, material and machine. Excessive compensation can weaken thin first-layer features.
Recheck the lid and card-well dimensions after the sample improves. Record the working setting with the model revision. If the problem extends through the full part height, stop treating it as a first-layer-only issue and investigate scale, extrusion or the designed clearance instead.
A useful comparison
A hypothetical tray measures 100.0 mm across the middle and 100.5 mm across the bottom edge. Its mating space is 100.3 mm. Shrinking the entire model might make it enter, but also reduces every internal well. A first-layer-specific test addresses the observed half-millimetre lip without assuming that the whole model is wrong.
Before you act
- Measure the bottom and middle separately.
- Distinguish a lip from warping or a rough seam.
- Retest after one controlled profile change.
Use the Fit workbook to apply the guide to your own setup.
Keep exploring
- Check a 3D-printed board game insert before printing the full set
- How to measure a board game box inside and out
Sources and research notes
Research checked on 21 October 2026. Product specifications are manufacturer statements; examples and buying judgements are our analysis. No hands-on product test is implied.
Build on what you just learned
Your next useful step.
Choose trays around the way you actually play.
Explore another topic →
